OVERVIEW OF SETTINGS (cont.)
Note 1
Always use a screwdriver when making further AIR adjustments to the arrow position on the
sensor.
Note 2
NO = normally open
NC = normally closed
DeEner = de-energized relay (active)
Energ = energized relay (passive)
Note 3
The sensor LED will briefly flash RED during monitoring communication with door control. This
indicates that external monitoring is functional.
Monitoring functionality must be active on the sensor and door control, and monitoring wires
must be properly connected to the door control.
Note 4
MTF = uni-directional with motion-tracking feature
uni + reentry: BEA recommends only adjusting using the LCD
Note 5
REDIRECTION setting (F1 on remote control):
R1-MW, R2-IR (F1=0):
R1 = MW (i.e. motion detection)
R2 = IR (i.e. presence detection)
R1-MW or IR, R2-IR (F1=1):
R1 = MW or IR (i.e. motion or presence detection)
R2 = IR (i.e. presence detection)
Note 6
partial: outputs are not reset
Page 10 of 12
NOTES
RADAR
AIR
NO = normally open
NC = normally closed
75.5751.12 IXIO-DT1 20230913