Electrical Safety - Stanley XR DCD700D2 Original Instructions Manual

f. Battery release button
g. Battery pack
h. Worklight
INTENDED USE
This drill/driver is designed for light fastening and drilling
applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This drill/driver is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities, or for lack of
experience and/or for want of knowledge or skills
unless they are supervised by a person responsible
for their safety. Children should never be left alone
to play with this product.

Electrical Safety

The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also
make sure that the voltage of your charger corresponds
to that of your mains.
Your D WALT charger is double insulated
e
in accordance with IEC 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable
for the power input of your charger (see Technical
Data). The minimum conductor size is 1 mm
maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fig. 3)
WALT
e
; the
2
WALT battery
e
WARNING: To reduce the risk of
serious personal injury, place the
forward/reverse button in the lock-off
position or turn tool off and disconnect
battery pack before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
NOTE: Make sure your battery pack (g) is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the
handle.
2. Slide it firmly into place until you hear the lock snap
into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (f) and firmly pull the
battery pack out of the tool handle.
2. Insert battery pack into the charger as described in
the charger section of this manual.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, place the
forward/reverse button in the lock-off
position or turn tool off and disconnect
battery pack before making any
adjustments or removing/installing
attachments or accessories.
Proper Hand Position (fig. 1, 8)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper hand
position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the main
handle (i).
Variable Speed Trigger Switch (fig. 1)
To turn the tool on, squeeze the trigger switch (a). To
turn the tool off, release the trigger switch. Your tool is
equipped with a brake. The chuck will stop when the
trigger switch is fully released.
The variable speed switch enables you to select the
best speed for a particular application. The further you
squeeze the trigger, the faster the tool will operate. For
maximum tool life, use variable speed only for starting
holes or fasteners
E NG LI S H
9