Table of Contents
Advertisement
Available languages
Available languages
Introduction for buttons on remote controller
Note:
Press this button continuously more than 2 seconds, the main unit will swing back
and forth from up to down, and then loosen the button, the unit will stop swinging
and present position of guide louver will be kept immediately.
press this button again 2 seconds later,
if press this button again within 2 seconds, the change of swing status will also
depend on the circulation sequence stated above.
8
SLEEP button
In the Cooling or Heating mode, press this button to start sleep mode. Once you set it up,
this symbol " " appears on the screen remote control. Sleep Mode has three places to
choose from, Sleep Mode 1, Sleep Mode 2, Sleep Mode 3. To navigate through the op-
tions, press the sleep button. By pressing it once Sleep Mode 1 " " will be activated, by
pressing it twice Sleep Mode 2 " " activates, three times Sleep Mode 3 " " activates.
Pressing the button for the fourth time will disable this function and " " will disappear.
If you deactivate the air conditioner, sleep mode will be deactivated. During DRY, FAN,
AUTO, Energy Saving & "8℃ Heating" functions, sleep mode is not available.
Sleep Mode 1
Sleep Mode 1 " " is available in Cooling or Heating mode. By activating this function, the
air conditioner's temperature increases by one degree per hour in "Cooling" mode and
decreases by one degree per hour in "Heating" mode.
Sleep Mode 2
Sleep mode 2 " " will only be activated during Cooling or Heating mode.
During Cooling mode:
-If the air conditioner temperature is set between 16 - 23℃, the temperature will increase
by one degree per hour for the next 3 hours after the power is turned on and then remains
stable. At the 8th hour after the operation is switched on, the temperature will be reduced
by one degree automatically.
-If the air conditioner temperature is set between 24 - 27℃, the temperature will increase
by one degree per hour for the next 2 hours from the start of the operation and then remain
stable. At the 8th hour after the operation is switched on, the temperature will be reduced by
one degree automatically.
.
status will switch to off status directly;
15
f to
, if
GB
Advertisement
Table of Contents
