Toyotomi TKG-628R32 User Manual page 14

Introduction for buttons on remote controller
5
Holding " " or " " button, 2 seconds later, set temperature on remote controller
will change quickly. On releasing button after setting is finished, temperature
indicator on indoor unit will change accordingly. (Temperature cannot be adjusted
under auto mode.)
TIMER TIMER
6
Press this button can select left and right swing angle. Fan blow angle can be selected
circularly as below:
(
Note:
Press this button continuously more than 2 seconds, the main unit will swing back
and forth from left to right, and then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
Under swing left and right mode, when the status is switched from off to
press this button again 2 seconds later
press this button again within 2 seconds, the change of swing status will also depend
on the circulation sequence stated above.
7
Press this button can select up and down swing angle. Fan blow angle can be selected
circularly as below:
louver will automatically swing up and down at maximum angle.
Hold " " button above 2 seconds to set your required swing angle. When reaching
your required angle, release the button.
.
status will switch to off status directly; if
14
(R
, if
GB
GB