Features Overview; Installation - Viking E-60-BN Product Manual

Entry phones now mount in a standard double gang box

Hide thumbs Also See for E-60-BN:

Technical practice (4 pages)

Technical practice (4 pages)

Product manual (9 pages)

Table Of Contents

Table of Contents

Mounting Screws:

3/4" Marine grade 316 stainless

steel, flat head, 5/64" hexdrive

screws (included).

Faceplate Material:

304 stainless steel. The SS model

has a #4 brushed finish, the BK,

BN and WH models have a

powder painted finish.

Microphone:

Omni-directional

microphone

with

water-resistant cloth.

Push Button Switch:

initiate

call,

push

disconnect. Solid 316 stainless

steel internally sealed per IP67.

Entry

Phone

Board:

Compact analog speaker

phone with call progress

detection

for

automatic

disconnect.

Microphone Volume

Speaker Volume

Earth Ground: To increase

surge protection, loosen the

screw labeled

(as shown)

and fasten a wire with ring

terminal (included) from the

mounting screw to Earth

Ground

(grounding

water pipe, etc.)

The E-60 is designed to be flush mounted into a standard double gang rough-in box with minimum

inside dimensions of 2.25" deep x 3.65" wide x 2.84" tall. The E-60 can also be surface mounted in a

Viking model VE-5x5 for mounting to a wall, post or Viking model VE-GNP gooseneck pedestal, EWP

model recommended (not included, see DOD 424). WARNING: Do NOT use a typical "wet location

box" as not all styles seal properly with the E-60 faceplate.

A. New Construction Flush Mounting

Front of box should stick out approximately ½" from front surface of wall stud (this may

Step 1

vary depending on the walls sheathing and siding thickness). Caution: Rough-In box

must be mounted LEVEL and must NOT stick out beyond the front surface of siding.

To maintain a vapor barrier on outside wall applications, caulk around the box, filling any

Step 2

gaps between the box and the rough opening. Apply caulk to any holes in the box around

wires, etc.

When installing siding cut a hole just large enough for the Rough-In box opening.

Caution: Too large of a hole can cause plate misalignment and compromise the gasket

Step 3

seal. Note: When mounting to 4 inch or less horizontal lap siding, a siding mounting block

can be used Contact siding installer for the correct mounting block. Note: A side

mounting block is recommended when mounting to vinyl siding.