TVS KING DELUXE Owner's Manual page 51

Rubber bellows for propeller shaft
Rubber bellows
Bellows should be kept in good condition and replaced
immediately if torn or cracked by approaching our
Authorized Distributor or Dealer or Authorized service
centers.
Torn or cracked bellows allow dust and water into the
propeller shaft flanges which will cause damage to flange,
slider block and pins. Inspect the bellows regularly.
ELECTRICAL
Head lamp bulb removal
To replace bulb
● Remove the headlamp bulb holder ( A ) from reflector
housing which is located under the dash board.
● Gently pull out the Rubber Boot (B) from reflector housing.
SELF MAINTENANCE PROCEDURE
A
A
Head lamp bulb removal
● Un-lock the clip ( C ) by loosening the star screw using star
screw driver to take out the bulb assembly.
● Push the bulb in and turn it in anti-clockwise direction to
remove the bulb from holder.
● Push the new bulb in and turn it in clockwise direction to fit
new bulb.
● Put back the clip & tighten the start screw. Assemble Rubber
boot & bulb Holder into reflector housing
Tail/brake/ rear turn signal lamp bulb
- Loosen and remove screws holding the lens.
- Remove lens. Push in and twist in anti clockwise direction to
remove bulb. Replace bulb and assemble back in reverse
order of disassembly.
C
B
49