Connect A Dc Power Supply To The Chassis; Install A Dc Power Supply Unit In The Chassis - Cisco 8600 Series Hardware Installation Manual

Connect a DC Power Supply to the Chassis

Locale Part Number
UPS 220V CAB-C19-CBN
Connect a DC Power Supply to the Chassis
When installing a DC-input Power Supply Unit (PSU), you will need access to the terminal block of the PSU
in order to connect the DC-input wires. If the front panel of the chassis has limited access because of other
interfering cables, consider connecting the DC-input wires to the terminal block, before you install the PSU
in the chassis. If you do have clear access to the terminal block, you can install the PSU in the chassis first
and then connect the DC-input wires.
The procedure to install the module in the chassis and the procedure to connect the DC-input wires have been
described in
on to the next, and finally power up the PSU.

Install a DC Power Supply Unit in the Chassis

Note
To install a DC-input Power Supply Unit (PSU) in the chassis, follow the steps described here.
Before you begin
Warning
Warning
Hardware Installation Guide for Cisco 8600 Series Routers
58
Cordset Rating
20 A, 250 VAC
Connecting the DC-Input Wires, on page
The power button has two modes of operation, which are described below. Press the power button for 10
seconds to toggle between modes; the LOCATE LED blinks for three seconds when you do.
• Auto-on: When in this mode, the power supply module automatically starts or restarts on application or
restoration of DC input power. This is the default mode.
For NEBS compliance, the power button must be in the auto-on mode. When power is restored after a
power failure, the power supply module recovers automatically.
• Protected: When in this mode, if the DC power source output voltage is zero, or drops out for more than
three seconds, you must press the power button for two seconds, to restore operation.
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1073 No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
AC Source Plug Type
Figure 50: 130923
61. You can complete either task first and then move
Powering on the Router