Table of Contents
Advertisement
LEDs
Table 10: MPA LED Descriptions
LED
Attention
Status
Port (for each
port)
Power Supply LED
For the AC PSU, the power module LEDs are located on the upper-left portion of the module. For a DC PSU,
the power module LEDs are located on the lower-right portion of the module.
Color
Status
Flashing Blue
The operator has activated this LED to identify this module in the
chassis.
Off
This module is not identified by the operator.
The module is in one of the following states:
Solid Amber
• Booting up
• Shutting down
• Power cycling
Solid Green
The module is operational with no issues.
Solid Red
The module has failed to power-up
Flashing Green
Auto or manual FPD upgrade is in-progress.
Flashing Red
The module has an active major or critical alarm.
Flashing Amber
The module has an active minor alarm.
Off
The module is in one of the following states:
• The module is in shutdown state by using either shutdown
• While the card is in running state, the ejector lever is opened
• The module is placed in shutdown state by the software due to
Note
The port is administratively enabled and the link is up.
Green
Amber
The port is administratively enabled and the link is down.
Off
The port is administratively shut down.
location location command in the EXEC mode or by using the
hw-module shutdown location location command in the
Config mode.
that triggers the auto-shutdown operation for the module.
a hardware fault or a critical alarm condition.
While in this state, the module can be safely removed
from the router.
Hardware Installation Guide for Cisco 8600 Series Routers
Power Supply LED
129
Advertisement
Table of Contents
