Table of Contents
Advertisement
Replace Chassis Components
The card unseats its connectors from the midplane and moves slightly out of the chassis.
Figure 69: Remove Route Processor Card from Chassis
1
3
f) Use one hand to hold the front of the card, place your other hand under the card to support its weight, pull
the card out of the chassis, and set it on an antistatic surface or inside an antistatic bag.
Step 4
To install a new card, follow these steps:
a) Pull the middle section of the ejector lever toward the end of the lever and rotate the lever away from the
front of the card.
This action opens the lever so that the card can be fully inserted into the slot.
b) Hold the front of the card with one hand and place your other hand under the card to support its weight.
c) Align the back of the card to the guides in the open route processor slot and slide the card all the way into
the slot (see the following figure).
The card stops when its front is about 0.25 inches (0.6 cm) outside the front of the chassis.
Unscrew the captive screw.
Rotate the ejector lever away from the card.
2
Release the latch.
4
Pull on the lever to slide the card partly out of
the chassis. Release the lever, hold the front of
the card, and pull the card all the way out of the
chassis.
Hardware Installation Guide for Cisco 8600 Series Routers
Replace a Route Processor Card
97
Advertisement
Table of Contents
