Connect Ac Power To The Chassis - Cisco 8600 Series Manual

Powering on the Router
Warning
• The source AC outlet must be within 9.84 to 14 feet (3.0 to 4.293 meters) of the system - depending on
• The AC power receptacles used to plug in the chassis must be the grounding type. The grounding

Connect AC Power to the Chassis

Warning
Warning
Warning
Warning
Statement 1022 Disconnect Device
To reduce risk of electric shock and fire, a readily accessible two-poled disconnect
device must be incorporated in the fixed wiring.
the length of the power cord, and should be easily accessible.
conductors that connect to the receptacles should connect to protective earth ground at the service
equipment level.
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1017 Restricted Area
This unit is intended for installation in restricted access areas. Only skilled, instructed, or qualified personnel
can access a restricted access area.
Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. To reduce risk of
electric shock or fire, ensure that the protective device is rated not greater than:
AC: 20A, DC: 50A
Statement 1028 More Than One Power Supply
This unit might have more than one power supply connection. To reduce risk of electric shock, remove all
connections to de-energize the unit.
Connect AC Power to the Chassis
Powering on the Router
3