Table of Contents
Advertisement
LEDs
Note
Table 14: Switch Card LED Descriptions
LED
Switch Card
Attention
Switch Card
Status
Fan Spinner LEDs
This section describes the Fan Spinner LEDs and their status.
These LEDs are for the fan board that controls the fan trays inserted in the four fan tray slots.
The Fan Board is hosted inside an SC. Fan Board controls the fan trays that are installed in the four fan tray
slots. The fan tray slots are located in the front panel of the SC.
Color
Flashing Blue
Off
Solid Amber
Solid Green
Solid Red
Flashing
Green
Flashing
Amber
Flashing Red
Off
Status
The operator has activated this LED to identify this module in the chassis.
This module is not being identified.
The module is in one of the following states:
• The module is powered on.
• Graceful chassis reload, shutdown, or reimage
This module is operational with no issues.
Power-up failure that prevents the card from powering up.
Auto or manual FPD upgrade is in-progress.
The module has an active minor alarm.
The module has major or critical alarms.
The module is in one of the following states:
• The module is in shutdown state by using either shutdown location
location command in the EXEC mode or by using the hw-module
shutdown location location command in the Config mode.
• While the card is in running state, the ejector lever is opened that
triggers the auto-shutdown operation for the module.
• The module is placed in shutdown state by the software due to a
hardware fault or a critical alarm condition.
Note
While in this state, the module can be safely removed from
the router.
Hardware Installation Guide for Cisco 8600 Series Routers
Fan Spinner LEDs
135
Advertisement
Table of Contents
