Table of Contents
Advertisement
Route Processor LEDs
LED
Status
Hardware Installation Guide for Cisco 8600 Series Routers
126
Color
Status
The module is in one of the following states:
Solid Amber
• Booting up
• Shutting down
• Power cycling
• Installing image
Solid Green
This module is operational with no issues.
Flashing Green
Auto or Manual FPD upgrade is in-progress.
Flashing Amber
The module has an active minor alarm.
Flashing Red
The module has an active major or critical alarm.
Solid Red
The module is in one of the following states:
• Power-up failure that prevents the CPU from booting.
• During bootup, if secure boot validation check fails on
BIOS, it causes the router to halt the booting process.
During run time, if secure JTAG detect tampering attempt
to the CPU JTAG chain, then the router halts the CPU and
sets the LED into this state.
Note
Off
The module is in one of the following states:
• The module is in shutdown state by using either shutdown
location location command in the EXEC mode or by using
the hw-module shutdown location location command in
the Config mode.
• While the card is in running state, the ejector lever is
opened that triggers the auto-shutdown operation for the
module.
• The module is placed in shutdown state by the software
due to a hardware fault or a critical alarm condition.
Note
The router displays two LEDs. Solid Blue for
Attention LED and Solid Red for Status LED.
While in this state, the module can be safely
removed from the router.
LEDs
Advertisement
Table of Contents
