Electrolux IPro R452a Operator's Manual page 9

R
- eassemble the parts of the dispensing tap,
making sure that the gaskets (J) are lubricated
with Vaseline grease so that the tap slides
smoothly back into its fixed position, until it's
completely inserted (see figure 11).
!Important!
T
he not perfect sliding of the tap
compromises its own seal.
R
- emove the drip tray and pulling it forward
W
(see figure 12).
then reassemble the parts by inversely following
the procedures described above.
P
- lug the unit back into appropriate power
supply.
A
- fter the cleaning and reassembly as per
above instructions, fill the bowl with a mix of
water and an approved sanitizer, according to
the measures specified.
S
- tart the mixing part of the machine to
sanitize all the parts following the cleaning
solution specifications.
D
- rain the cleaning solution as follows:
U
• nscrew the two knobs;
T
• hen lower the bowl to drain out any
remaining product through the
dispensing valve.
S
- crews the knobs to fix the bowls.
Data di emissione: July, 2023
ash each part thoroughly,
Revisione: 01
Fig. 11
Fig. 12
Pag. : 9/52