Electrolux IPro R452a Operator's Manual page 6

E
- mpty the bowl of any remaining product.
A
- fter unlocking the main cover with its key,
remove it.
F
- ill the bowl with lukewarm water to help
melt off any sugar residuals and drain this water
before proceeding with the next step.
!Caution!
T
o avoid electrical shock or contact with
moving parts, before proceeding with the
disassembling operations, make sure all
switches are in "OFF" position and that the
main power supply is disconnected.
U
- nscrew and slip off the knobs (fig.1) then
lower the bowl to eliminate any product residue
through the dispensing tap.
S
- lightly move up and down the bowl as
shown in figure 2 while pulling it outwards, this
operation will help fully removing it from its
seating.
S
- imultaneously apply pressure to the two
securing tabs (Q) and lift the dispensing tap (I)
to pull it out of its fixed position (see figure 3).
D
- isassemble the dispensing tap by keeping
the indicated part (R) pressed down and slipping
off the dispensing lever (L) (see figure 4).
T
- horoughly wash each single part with hot
water and mild dishwashing detergent, rinse
well, and reassemble the parts.
!Caution!
T
o prevent bacteria growth, remove all
o-rings when cleaning.
F
ailure to do so could create a health
Data di emissione: July, 2023
hazard.
Revisione: 01
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Pag. : 6/52