Table of Contents
Advertisement
O
nce performed all these cleaning and
sanitizing procedures, it's possible to
reassemble all the components.
T
he correct assembly of the device is essential
to prevent leakage of product and damage of
T
the machine.
o assemble the machine you will
need an approved lubricant (such as vaseline).
M
ake sure all parts have been washed and
sanitized before assembling.
assembling the machine must first wash and
sanitize their hands and forearms with an
approved sanitizer.
M
-
ount the mixing system back together
(fig.5), according to the following procedures:
S
•
pread the suction gaskets (X) with
Vaseline grease to reduce friction and
thus limit wear (fig.7).
M
•
ount the bowl seal (T) making sure it
faces the right direction (fig.8).
A
•
ssemble the scraper auger (U), making
sure the head is perfectly engages with
the driving shaft.
S
•
ecure all the parts into place by
screwing the bolt (S) in a counter
clockwise direction.
M
-
ount the bowl back on, positioning it into
place, and making sure that it has a tight hold
on its gasket (see figure 10).
procedure, lubricate the rear part of the bowl at
the point in which it fits together with its sealing
(fig.9).
S
-
ecure the bowl by tightening the two knobs,
without exerting excessive pressure.
IMPORTANT
D
o not over tighten the bowl knobs.
E
xcessive force could damage the thread
and/or the bowl itself.
Data di emissione: July, 2023
P
ersons
T
o facilitate this
Revisione: 01
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Pag. : 8/52
Advertisement
Table of Contents
