Erasing Fault Codes - Volvo Penta TAD941GE Operator's Manual

Fault Handling
36
Easy Link Instruments
1 When the system detects a fault the diagnostics
lamp flashes.
2 Press the diagnostics button. The fault code is
shown as text in the tachometer display.
3 Look up the fault code in the Fault Code Register
and take the necessary actions.
4 When the fault has been rectified, the fault code
disappears from the display and the diagnostics
lamp goes out.
If the diagnostics lamp is pressed after the fault has
been rectified and the fault code erased, the code 1.1,
No fault will be displayed.

Erasing fault codes

The memory of the diagnostic function is reset when
the power to the engine is disconnected.
When the power is switched on again the diagnostic
function will check if there are any malfunctions in the
system. If so a new fault codes is registered.
NOTICE! Power must be disconnected completely.
This means that fault that hasn't been corrected:
1 are shown as active, the active fault code can then
be erased with the VODIA tool.
2 must be acknowledge and read out every time the
engine is switched on.
If the diagnostic button is depressed after the fault has
been corrected and fault code deleted, the code 1.1,No
fault, will show.
47702660 03-2013 © AB VOLVO PENTA