Table of Contents
Advertisement
Fault handling
54
Easy Link Instruments
1 When a malfunction is detected this is reported by
the diagnostic lamp which starts to flash.
2 Press the diagnostics button. The fault code is
shown as text in the tachometer display.
3 Look up the fault code in the Fault Code Register
and take the necessary actions.
4 When the fault has been rectified, the fault code
disappears from the display and the diagnostics
lamp goes out.
Erasing fault codes
The memory of the diagnostic function is reset when
the power to the engine is disconnected. When the
power is switched on again, the diagnostic function will
check if there are any malfunctions in the system. If so
a new fault codes is registered.
If a malfunction has not been corrected it will be
registered once again and has to be acknowledged
again. The Volvo Penta diagnostic tool VODIA must be
used to erase a fault code.
47711097 09-2018 © AB VOLVO PENTA
Advertisement
Table of Contents
