Power Supply
The oscilloscope is supplied with one external power supply and set of
(6) 1.2 V NiMH rechargeable batteries 2700 mA·h.
When the supplied wall plug is connected from the instrument to an external
power source, battery power is not needed. The batteries are only used when
there is no external power supply available.
Before the first use, start by fully charging the battery.
NOTE:
The batteries automatically begin charging when the
Oscilloscope is powered off, but connected to an external power supply
When the batteries are charging, the Battery Charge LED on the front panel will
turn on steady.
The LED will blink in the following situations:
pre-charge of very low batteries
temperature is too low or too high
batteries are damaged
When the charge is complete, the LED will turn off.
If the batteries need to be replaced, they must be replaced with NiMH
rechargeable batteries. Battery charge life is guaranteed for same-capacity
batteries (in mA·h) as those shipped with the oscilloscope.
To remove the battery cover, use a coin to turn the slot on the back of the unit
counter-clockwise.
Description
The Handscope Oscilloscope Model OX 5022B combines three instruments into
one:
20 MHz oscilloscope
Independent 8000 ct multimeter with power measurements
Built-in harmonic analyzer out to the 31
20 Hz and 450 Hz)
The instrument operates at a constant acquisition depth of 2500 points.
An LCD TFT screen is used to view the applied signals along with all the setting
parameters.
The main command functions are accessible using the buttons on the front
panel.
A graphic interface is used to:
adjust the parameters related to the selected button
navigate using a horizontal main menu showing the current settings and
vertical sub-menus
Handscope Harmonic Analyzer Oscilloscope Model OX 5022B
harmonic (fundamental between
st
.
7