Table of Contents
Advertisement
Bear in mind that food which spoils easily should not be left in
the cooking compartment for too long.
Set the operating mode and temperature for the bottom oven.
1.
The bottom oven starts heating.
Press the
clock function button repeatedly until
KJ
2.
the
and
symbols light up.
KJ
x
Set the cooking time with the rotary selector
3.
(e.g.
‚
:
„‹
hours).
The setting is applied automatically.
Press the
KJ
clock function button repeatedly until the
4.
and
symbols light up.
y
Set the end of operation using the rotary selector
5.
(e.g.
‚ƒ
:
„‹
o'clock).
The bottom oven switches off and waits until the correct time
to switch on (in the example at
switches off automatically at the time set for the end of
operation
:
‚ƒ
„‹
Turn the operating mode and temperature selector back to
6.
the
position.
Û
Press the
clock function button to exit the clock function.
KJ
7.
Setting the clock
You can only change the clock when no other clock function is
active.
Press the
clock function button repeatedly until
KJ
1.
the
and
symbols light up.
KJ
3
Set the clock using the rotary selector.
2.
The setting is applied automatically.
Baking
In this section, you will find information on
Baking on one level
■
Baking on two or more levels
■
The baking table
■
The baking table for ready-made products
■
Tips and tricks for baking
■
Note: Do not use shelf height 2 when baking with
CircoTherm®. The air circulation is impaired and this will have
a negative effect on your baking.
We recommend that you use dark baking tins made from metal.
Tinplate and glass dishes increase the baking time required
and the cake will not brown evenly.
If you wish to bake using tinplate tins and
you should use shelf height 1.
8
KJ
:
). The bottom oven
‚‚
‹‹
3
%
Top/bottom heat,
Rapid heat up
With
3
CircoTherm®, you can shorten the heat up time if your
selected temperature setting is higher than 100 °C.
Note: During Rapid heat up, do not place any food in the
cooking compartment for as long as the
Set the operating mode and temperature for the bottom oven.
1.
The bottom oven starts heating.
Press the
clock function button repeatedly until the
KJ
2.
and
symbols light up and
f
display.
Turn the rotary selector clockwise.
3.
In the clock display,
Ž
up. Rapid heat up is activated for the bottom oven.
After reaching the set temperature, Rapid heat up switches off.
The
f
symbol goes out.
Checking, correcting or deleting settings
To check your settings, press the
1.
repeatedly until the corresponding symbol lights up.
If necessary, you can correct your setting using the rotary
2.
selector.
If you wish to cancel your setting, turn the rotary selector anti-
3.
clockwise to the original value.
Always slide the universal pan in carefully as far as it will go
and make sure that the sloping edge is facing the appliance
door.
Slide the flat wire racks in so that the rear upstand is at the rear.
The baking tins therefore cannot slide off the back of the shelf.
Baking on one level
If you are baking on one level with
place a round tin in the centre of the stepped wire rack
(Figure A) and always place a loaf tin diagonally (Figure B).
$
$
symbol is lit.
f
is displayed in the clock
Œ
is displayed and the
symbol lights
f
clock function button
KJ
3
CircoTherm®, always
%
%
KJ
Advertisement
Table of Contents
