Cleaning The Door Panels; Cleaning The Hook-In Racks - NEFF U17M72 0GB Series Instruction Manual

Cleaning the door panels

To facilitate cleaning, you can remove the door panels from the
appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Unhook the appliance door and lay it on a soft, clean surface
1.
with the front side facing downwards (see section:Removing
and installing the appliance door).
Grip the door panel next to the hinges and pull it out of the
2.
plug-in holders (not visible).
Lift the door panel slightly and remove it in the direction of the
3.
hinges.
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
Press the left and right-hand holders outwards.
1.
The intermediate panel disengages upwards.
Lift the intermediate panel slightly and take it out.
2.
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
Insert the intermediate panel on the left and right into the
1.
supports.
Push the intermediate panel downwards in the retainers.
2.
Fitting the door panel
Insert the door panel on the left and right into the supports.
1.
Press the door panel downwards into the plug-in holders.
2.
Refit the appliance door.
3.

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side.
Pull the hook-in rack forwards at the rear and unhook to the
2.
side.

Clean the hook-in racks with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
upwards, so that the shelf heights match.
Insert the hook-in rack at the rear until the limit stop.
5.
Push the hook-in rack towards the rear.
6.
Insert the hook-in rack at the front until the limit stop.
7.
Push the hook-in rack downwards.
8.

19