Automatic Calibration; Before Using The Appliance For The First Time; Setting The Language; Setting The Clock - NEFF C47C42S0 Instruction Manual

Accessories
Cooking container, solid, GN
deep
Cooking container, perforated, GN
40 mm deep
Cooking container, solid, GN
deep (baking tray)
Cooking container, solid, GN
deep
Cooking container, perforated, GN
40 mm deep
Porcelain cooking container, solid, GN
Porcelain cooking container, solid, GN
Wire rack
Roasting set
Cleaning sponge
Descaler
Honeycomb microfibre cloth

Before using the appliance for the first time

In this section you will find out which steps are required before
using the appliance for the first time:
Setting the clock and language
■
Setting the water hardness range
■
Starting the appliance for the first time
■
Cleaning the accessories before use
■
Fitting the grease filter
■

Setting the language

Once the appliance has been connected to the power supply,
you must set the language for the text display.
Turn the temperature selector until the language you require
1.
appears on the text display.
Press and hold the info button for 3 seconds.
±
2.
Your setting is saved.
6SUDFKH ZlKOHQ
'HXWVFK
Order no.
Z1683X0
, 40 mm
Z
, Z1682X0
Z
Z1673X0
, 28 mm
Z
Z1663X0
, 40 mm
Y
Z1662X0
,
Y
Z1685X0
Z
Z1665X0
Y
Z1664X0
Z1684X0
643 254
311 138
460 770
The cooking containers may warp during cooking. This is
caused by the considerable temperature differences on the
accessories. It may occur if only a part of the accessory is
covered or if you place frozen items, such as pizza, on the
accessory.

Automatic calibration

The boiling temperature of water depends on the air pressure.
During calibration, the appliance is adapted to the pressure
conditions in the location where it is installed. This happens
automatically when you first use the appliance (see section:
First use). More steam develops than usual.
It is important that the appliance steams without interruption for
20 minutes at 100 °C. Do not open the appliance door during
this time.
If the appliance was not able to calibrate itself automatically (for
example, because the appliance door was opened), the
calibration process is carried out again during the next cooking
operation.
After moving house
So that the appliance automatically adjusts itself to its new
location, you must reset the appliance to the factory settings
(see section: Basic settings) and repeat the initial start-up
process (see section: First use).
After a power cut
The appliance saves the calibration settings even in the event
of a power cut or disconnection from the mains. Recalibration
is not necessary.
Changing the language
Your appliance must be switched on.
If required, turn the operating mode selector to the
1.
Press and hold the ± info button for 3 seconds.
2.
This takes you directly to the language selection screen.
Turn the temperature selector until the language you require
3.
appears on the text display.
Press and hold the info button for 3 seconds.
±
4.
Your setting is saved.

Setting the clock

Note: When you press the
3 seconds to set the clock using the rotary selector. Should this
have been insufficient for you, you can amend the clock time
later.
: flashes in the clock display.
‹ ‹‹
Briefly press the clock function button to go to the
KJ
1.
setting mode.
The and symbols light up.
KJ 3
clock display.
Set the current time using the rotary selector.
2.
Your setting is accepted after 3 seconds.
clock function button, you have
KJ
: appears in the
‚ƒ ‹‹
position.
Û
7