Chapter 5. Troubleshooting - Kernau KFCF 1004 EW User Manual

CHAPTER 5. TROUBLESHOOTING

CAUTION:
Before troubleshooting, disconnect the power supply. Only a qualified electrician or competent person must
do the troubleshooting that is not in this manual.
IMPORTANT:
There are some sounds during normal use (compressor, refrigerant circulation).
PROBLEM
Appliance
does not work
Appliance freezes
too much
The food is not
frozen enough.
Heavy build-up of
frost on the door
seal.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the
rating plate.
POSSIBLE
CAUSE
Mains plug is not plugged in
or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cols or the
appliance runs at MAX setting.
Temperature is not properly
adjusted.
Dor was open for an
extended period.
A large quantity of warm food
was palced in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air-tight
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
SOLUTION
Insert mians plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to
a warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the Installation
Location section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a
cool setting). At the same time shape
the warmed door seal by hand such that
it sits correctly.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
EN 36