Product Security Policies - Epson SureColor SC-P10070 Network Manual

* Encrypting communications: There is potential for data theft if product settings are adjusted
over a secure network. If no other network is available, follow the steps below to encrypt the data
for transmission.
(1) In the product control panel, select Network Setup > IPsec Setting > Enable and enter the
pre-shared key.
(2) Set up IPsec on the computer that will be used to configure the product.
(3) Connect the product and the computer that will be used to configure the product to the
network.
c
Important:
The network connection will close if Network Setup > IPsec Setting is enabled in the product
control panel and a blank key is entered for PSK Setting (i.e. no pre-shared key is entered). Be sure
to enter a key for PSK Setting after enabling Network Setup > IPsec Setting in the product
control panel.

Product Security Policies

Start the product Remote Manager from your computer, open the Setup tab, and adjust Security >
IPsec/Access Control settings for security policies that match how the product will be used.
Note:
We recommend that the product be assigned a static IP address for secure access using IPsec or Access
Control. Settings will be invalidated if the IP address changes.
Sample 1
Open the Setup tab in Remote Manager and configure Security > IPsec/Access Control > Default
Policy settings as follows:
Option
IPsec/Access Control
Default Policy > Access Control
Pre-Shared Key
Setting
Enable
Use IPsec
Enter a key (maximum 127 alphanumeric
characters)
Epson Network Guide
Tips for Administrator 52