Table of Contents
Advertisement
EpsonNet Config's setting screens
TCP/IP, WSD, UPnP, Bonjour
The following table lists the components required for network printing.
Printing method
TCP/IP printing
4. Double-click Internet Protocol (TCP/IP) on the Local Area Connection Properties dialog box to
open the Internet Protocols (TCP/IP) Properties dialog box. Set the IP address, the subnet mask,
etc. and then click OK.
5. Restart the computer.
The necessary components are now installed. Go to the section "Setting Up the Network Interface" on
page 18.
Mac OS
To assign an IP address, subnet mask, etc. to your Mac OS, follow the steps below.
1. From the Apple menu, select System Preferences.
2. Open the Network control panel. Click the TCP/IP tab.
Note:
For Mac OS X 10.6 or later, select Ethernet as the connecting method on the Network control panel,
select the method to assign the IP address from the Configure menu, and then assign the IP address.
3. Select Built-in Ethernet from the Show pull-down menu.
4. Assign an IP address and other settings if necessary.
5. Click the Apply Now button to save any changes.
Go to the section "Setting Up the Network Interface" on page 18.
Necessary components
Internet Protocol (TCP/IP)
Necessary components
Internet Protocol (TCP/IP)
Epson
Network Guide
How To
17
Advertisement
Table of Contents
