Operation - HAMPTON BAY DERRY GLF-2002 Use And Care Manual

Operation

NOTE: When the heat function is used for the first time, a slight
odor may be present. This is normal and should not occur again
unless the heater is not used for an extended period of time.
1
Using the Control Panel
Check that the heater outlet grill is not covered or
obstructed in anyway, and make sure the power to the
unit is switched on.
Press the appropriate button to operate your fireplace:
1. Main Power Button: This button supplies power to all
of the fireplace functions. It must be turned on for the
fireplace to work.
2. Heater Control Button: This button controls the heater
ON/OFF and 5 temperature modes from Low to High.
When the heater is first turned on, it will come on at
the lowest room temperature setting. The log set will
remember the last heat setting and in later use the
heater will start at that setting, unless power to the
unit has been interrupted. Each time the temperature
button is pressed, the temperature set point increases,
allowing you to adjust the ambient temperature.
3. Heater Locking Function: When fireplace is ON, press
the main power button (1) for 10 seconds. The heater
will be locked, and the heater control button (2) on the
control panel as well as on the remote control will be
disabled. Before the heater is locked, the flame will
flash 6 times. To unlock the the heater, press the main
power button (1) for 10 seconds. Before the heater is
unlocked, the flame will flash 6 times.
4. Flame Control Button: This button controls the
brightness of the flame effect with settings at High,
Medium, and Low. When the log set is first turned on,
the flame will come on at the highest setting. The log
set will remember the last flame setting used and in
later use the flame brightness will start at that setting,
unless power to the unit has been interrupted. Each
time the flame button is pressed, the flame brightness
decreases. The only way to turn off the flame effect
completely is to turn off the main power button (1).
4
10
3
2 1