Operation - HAMPTON BAY SF103-18H Use And Care Manual

Operation

NOTE: When the heat function is used for the first time, a slight
odor may be present. This is normal and should not occur again
unless the heater is not used for an extended period of time.
1
Using the Control Panel
□ Check that the heater outlet grill is not covered or
obstructed in anyway, and make sure the power to the unit
is switched on.
□ The fireplace can be accessed in two ways: Using the
touchpad control panel, or using the multifunction remote
control unit.
□ Press the appropriate button to operate your fireplace:
1. Main Power Button: This button supplies power to
all of the fireplace functions. It must be turned on for
the fireplace to work.
2. Heater Control Button: This button controls the
heater ON/OFF. When the temperature unit is set as "F"
or "C", the temperature scope is as follows:
"F"= Fahrenheit temperature 82°F, 81°F, 80°F, 79°F,
78°F, 77°F, 76°F, 75°F, 74°F, 73°F, 72°F, 71°F, 70°F,
69°F, 68°F, 67°F, 66°F, 65°F, 64°F, 63°F, 62°F.
"C"= Celsius temperature 27°C, 26°C, 25°C, 24°C,
23°C, 22°C, 21°C, 20°C, 19°C, 18°C, 17°C.
3. Flame Control Button: This button controls the
brightness of the flame effect with settings at High
(L3), Medium (L2), and Low (L1). When the log set is
first turned on, the flame will come on at the highest
setting. The log set will remember the last flame
setting used and in later use the flame brightness will
start at that setting, unless power to the unit has been
interrupted. Each time the flame button is pressed,
the flame brightness decreases. The only way to turn
off the flame effect completely is to turn off the main
power button (1).
NOTE: After the fireplace has been operating, when the unit is turned off, the fan (not the heater) will continue to run for about 1 minute to cool
down the interior of the unit. During this time, you may feel cool air from the blower outlet. This is normal and does not require any action. The
fan will stop once the interior cools down.
4. Timer Button: This button controls the ON/OFF and
7-time setting from 30 minutes to 6 hours. When the
Timer is first turned on, it will come on at the shortest
time setting (30 minutes). Each time the Timer button
is pressed, the time increases 1 hour, up to the
longest setting (6 hours). Once the set time expires, all
fireplace functions will be automatically turned off.
5. Fahrenheit/Celsius Display: This button displays
F (Fahrenheit) or C (Celsius) depending on how the
temperature mode is set. When the heater is on, press
and hold the Power Button for 5 seconds. The display
will beep and switch between Fahrenheit and Celsius.
The fireplace will remember the last heat setting, and
in later use, the heater will start at that setting, unless
power to the unit has been interrupted.
6. Temperature/Timer Display: This LED display
shows the set point for the temperature and timer
functions. When either of these functions is activated,
the display reflects the set point for five seconds and
then fades to black. Any change in the set point of the
temperature or timer will reactivate the display, which
again fades after five seconds.
10
1
4
3
2