Operation - HAMPTON BAY Blaise CFI031ARU Use And Care Manual

Operation

Operation
NOTE:
The control panel can be accessed at the right side of the fireplace.
1
Powering the fireplace
Push the Power button to supply power to all
functions of the fireplace and put the unit in a
standby mode.
Push the Power button again to turn off all functions.
NOTE:
All previous settings are held in memory, so the
next time you power up the fireplace, the unit will turn on
with the same settings.
3
Adjusting the thermostat
The thermostat knob controls the thermostat setting.
Turning the knob clockwise will increase
thermostat setting. Rotating the knob
counterclockwise will decrease the
thermostat setting.
When the heater reaches the thermostat setting it will
turn off until the room cools at which point the heater
will turn back on.
2
Adjusting the flame
There are 5 brightness levels that can be selected:
Pressing the flame button on the control panel will cycle
through the flame settings.
The "
decrease flame output.
4
Turning the heat on and off
The HEAT button will turn ON/ OFF the heater.
NOTE:
Holding the heater button on the control
panel for 10 seconds will disable the heater
function.
5
Playing the emberbed undulation effect
This button on the remote control plays or pauses the
undulating emberbed effect.
6
" buttons on the remote will increase /