Breville Dose Control Pro BCG600SILUSC Instruction Book page 10

Step 4:
Trimming the Dose
The adjustable Razor™ Dose Trimming Tool
allows you to trim the puck to the right level for
a consistent extraction. Select the correct width
blade of the Razor™ to match the diameter of
your filter basket. The Razor™ has three blades of
varying widths: 58mm, 54mm and 50mm. The
58mm and 54mm are already fitted within the
Razor™ body. The 50mm is separate.
54mm
If you require the 50mm blade, turn the
Adjustable Dial past #1 until the 54mm
blade is fully extended and able to be pulled
from the body.
NOTE
The Adjustable Dial may feel tight as you
continue to wind it towards the end of its travel.
Insert the 50mm blade into the body. Wind the
Adjustable Dial until the blade is retracted past
#4. Press the 50mm and 58mm blades at the
same time, towards the center of the body until a
"click" sound can be heard.
10
50mm
ADDITIONAL BLADE
54mm
50mm
Adjust the Razor™ to the setting in the table
below for your Breville espresso machine. This
is a starting point for your dose height.
Breville Espresso
Machine
BES900XL/920XL
BES870XL
BES840XL
BES810BSS
800ESXL
After tamping the coffee, insert the Razor™
into the filter basket until it rests on the rim of
the basket. The blade of the dosing tool should
penetrate the surface of the tamped coffee.
If the blade does not penetrate the surface
of the tamped coffee, your coffee is under
dosed. Increase the amount of dosed coffee by
adjusting the GRIND TIME dial.
Rotate the Razor™ back and forth while holding
the portafilter on an angle over the knock box
to trim off a little excess coffee.
APPLY PRESSURE
AT BOTH ENDS
'CLICK'
Portafilter Dose
Size Height
58mm 2
54mm 2.5
54mm 2.5
54mm 2.5
50mm 3