Safety Information - Elatec TWN4 MULTITECH 2 HF User Manual

3 SAFETY INFORMATION

Transport and storage
•
Observe carefully the transport and storage conditions described on the product packaging or other relevant product documents
(e.g. data sheet).
Unpacking and installation
•
Before unpacking and installing the product, this user manual and all relevant installation instructions must be read and understood
carefully.
•
The product is equipped with a cable.
o
Do not twist or pull the cable.
o
Do not replace the cable and do not use a cable extension.
ELATEC excludes any liability for damages or injuries resulting from the use of the product with a cable extension or a
replaced cable.
•
In order to comply with the applicable RF exposure requirements, the product should be installed and operated with a minimum
distance of 5 cm to any user's/nearby person's body at all times. Refer to Chapter "Compliance statements" for further information
about RF exposure compliance.
Handling
•
Depending on your product configuration, the product might be equipped with one or more light-emitting diodes (LED).
Avoid direct eye contact with the blinking or steady light of the light-emitting diodes.
•
The product has been designed for a use under specific conditions, e.g. in a specific temperature range (refer to the product data
sheet).
Any use of the product under different conditions might damage the product or alter its reading performance.
•
The use of other RFID readers or reader modules in direct vicinity to the product, or in combination with the product might damage
the product or alter its reading performance. In case of doubts, contact ELATEC for more information.
•
The user is liable for the use of spare parts or accessories other than the ones sold or recommended by ELATEC.
ELATEC excludes any liability for damages or injuries resulting from the use of spare parts or accessories other than the ones sold
or recommended by ELATEC.
•
Like most electronic devices, RFID systems generate electromagnetic waves that can vary in amplitude and frequency. It is
generally known and accepted that some RFID devices might potentially interfere with personal medical devices, like pacemakers
or hearing aids.
TWN4 MultiTech 2 HF fulfills general radio and EMC requirements. However, users with a pacemaker or any other medical
device should use TWN4 MultiTech 2 HF carefully and refer to the information given by the manufacturer of their medical
devices before using TWN4 MultiTech 2 HF or any host device containing TWN4 MultiTech 2 HF.
Maintenance and cleaning
•
Any repair or maintenance work should be done by a trained and qualified personnel only.
Do not try to repair or carry out any maintenance work on the product by yourself.
Do not allow any repair or maintenance work on the product by an unqualified or unauthorized third party.
•
The product does not need any special cleaning. However, the housing may be carefully cleaned up with a soft, dry cloth and a
non-aggressive or non-halogenated cleaning agent on the outer surface only.
Make sure that the used cloth and cleaning agent do not damage the product or its components (e.g. label(s)).
© 2023 ELATEC GmbH – TWN4 MultiTech 2 HF user manual – DocRev03 – EN – 07/2023 Page 5 of 14