Advertisement
Quick Links
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: K-VS1000-19-17-01-SL / K-VS1000-19-17-02
Part Description: Crash Bar – KAWASAKI VERSYS 1000 / 2019-2021
Applicable to both Stainless Steel and Steel Versions
Installation / Parts List / Bill of Material for Mounting
Copyright By SRC
Design and Specification are subjected to change
Page 1
Advertisement
Related Manuals for SRC K-VS1000-19-17-01-SL
Summary of Contents for SRC K-VS1000-19-17-01-SL
- Page 1 Scope of Supply/Bill of Material & Mounting Drawings Part Number: K-VS1000-19-17-01-SL / K-VS1000-19-17-02 Part Description: Crash Bar – KAWASAKI VERSYS 1000 / 2019-2021 Applicable to both Stainless Steel and Steel Versions Installation / Parts List / Bill of Material for Mounting...
- Page 2 Copyright By SRC Design and Specification are subjected to change Page 2...
-
Page 3: Mounting Instructions
Orient, Mount and Fit the Top Bracket (3) to the Motorbike Chassis frame (as show) Use M8 x 40 Screw (9) – 2 off and Washer M8 (17) – 2 off, as shown in the BOM table and the drawing. Copyright By SRC Design and Specification are subjected to change Page 3... - Page 4 Slip - in The Top Hollow end of Crash Bar RH&LH, has to be aligned to the Upper Bracket (3) as shown, and slip-in the screw M6x15 (8)-2 off, the washer M6 (16)-2 off Copyright By SRC Design and Specification are subjected to change...
- Page 5 Slide-in the Screw M10 x 40 (10) – 1 off, the long screw M10 x 330 (13) – 1 off, and through the Mounting hole in the Crash Bar Lower LH (1) to the motorbike ( as show red color ) Copyright By SRC Design and Specification are subjected to change...
- Page 6 Washer M6 (16) – 2 off Screw M6 x 15 (8) – 2 off and secure the threads in the other end of the Pin pipe (5). Copyright By SRC Design and Specification are subjected to change Page 6...
- Page 7 Alignment of the Crash bars Ensure mounting symmetry of the Slider Bars visually (it must not be offset or shifted visually when seen from the front side and back side) Copyright By SRC Design and Specification are subjected to change Page 7...
-
Page 8: General Information
Right Hand ) mounted and joined using the Side Brackets & Top bracket with a Welded Cylindrical block, as shown in the subsequent drawings SRC’s Crash Bar protects the user, in the event of a fall or skidding of the vehicle. We request you to pay attention to the Mounting Instructions in this document and follow the step- by-step procedures.