SRC BMW-R1200GS-09-01-AL Mounting Instructions

Download this manual

Scope of Supply/Bill of Material & Mounting Drawings

Part Number: BMW-R1200GS-09-01-AL / BMW-R1200GS-09-02-AL

Part Description: Engine Guard–BMW R1200 GS

Applicable to Finished colour versions of Silver and Black

Installation / Parts List / Bill of Material for Mounting

No. Description

1 Skid Plate

2 Taper Ring M6

3 Special Pin

4 Screw M6 x 10

SRC Design uses Metric System of Measurement and all dimensions are in Millimeters

* Recommended to use the Torque specified in the table

** Denotes Usage of Liquid Thread Locker in specified locations

Design and Specification are subjected to change

Quantity Torque * (N-m) Remarks **

8-10

Use Liquid Thread Locker

Page 1

Page 1 4 Screw M6 x 10 8-10 Use Liquid Thread Locker SRC Design uses Metric System of Measurement and all dimensions are in Millimeters * Recommended to use the Torque specified in the table ** Denotes Usage of Liquid Thread Locker in specified locations...
Page 2: Mounting Drawings
MOUNTING DRAWINGS Copyright By SRC Design and Specification are subjected to change Page 2...
Page 3: Mounting Instructions
These special pins, are made out of Rubber, which act as cushions. The projections, have threads, to suit the Mounting threads in the Underside of the Engine. Copyright By SRC Design and Specification are subjected to change Page 3...
Page 4 The threads can be tightened as specified in the BOM table. The final mounted condition of the Skid Plate (Engine Guard) is as shown, in the drawing below. Copyright By SRC Design and Specification are subjected to change Page 4...
Page 5 Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and its functional aspects. 3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It is advised to the User, to inspect and ensure the original state of all other Vehicle parts.

Bmw-r1200gs-09-02-al