SRC K-VS1000-19-17-01-SL Manual page 4

Step: 4
Slip - in The Top Hollow end of Crash Bar RH&LH, has to be aligned to the Upper
Bracket (3) as shown, and slip-in the screw M6x15 (8)-2 off, the washer M6 (16)-2 off
Copyright By SRC
Design and Specification are subjected to change
Step: 3
Use the Nut M8 (12) - 2 off as shown in
the BOM table and the drawing.
Do not tighten the screws fully.
Page 4