Changing The Engine Oil; Cleaning And Adjusting The Spark Plug - Champion 93001i-DF-UK Operator's Manual

93001i-DF-UK - 3000W DUAL FUEL INvERTER GENERATOR

Changing the Engine Oil

Recommended every 100 hours or annually Change oil when the
engine is warm. Refer to the oil specification to select the proper
grade for your operating environment.
1. Set the generator on top of a work bench or table.
2. Loosen the fasteners and remove the maintenance cover.
3. Remove oil fill cap/dipstick.
4. Tilt the generator on its side and allow the oil to drain
completely.
5. Add oil according to Add Engine Oil in Assembly section.
DO NOT OVERFILL. Oil not included for routine maintenance.
6. Replace oil fill cap/dipstick and secure maintenance cover.
7. Dispose of used oil at an approved waste management
facility.

Once oil has been added, on flat level surface as a general rule
oil should be visible about 1-2 threads from top of the oil port
hole. If using the dipstick to check oil level, DO NOT screw in
the dipstick while checking simply rest it against the top of the
port and take reading.
NOTICE

Cleaning and Adjusting the Spark Plug

1. Recommended every 50 hours use or annually. Remove the
maintenance cover.
2. Remove the spark plug cable from the spark plug.
3. Use a spark plug socket tool ), or a 13/16 in. (21 mm) socket
to remove the plug.
4. Inspect the electrode on the plug. It must be clean and not
worn to produce the spark required for ignition.
5. Make certain the spark plug gap is
0.024-0.031 in. (0.6-0.8 mm).
6. Refer to the spark plug types in Specifications when replacing
the plug.
7. Firmly re-install the plug.
8. Attach the spark plug cable to the spark plug.
9. Reinstall the spark plug access cover.
27
MAINTENANCE
SPARK PLUG GAP