Remove Pedals; Remove Stabilizers - LifeFitness LIFECYCLE GX Service Manual

Remove Pedals

Tools required: 15mm Open End Wrench
1. Remove the right pedal (B) by turning it counterclock-
wise.
2. Install the right pedal (B) by turning it clockwise.
3. Remove the left pedal (A) by turning it clockwise.
4. Install the left pedal (A) by turning it counterclockwise.
Pedals: 35 ft.lbs. (45Nm)

Remove Stabilizers

Tools required: 13mm & 17mm Socket Wrench
Note: Removal and replacement of front stabilizer shown,
the rear stabilizer is removed and replaced the same way.
1. Using a 17mm socket wrench, remove 2 each bolts (A),
washers (B), and plastic washers (C) from the stabilizer
assembly (D).
2. Using a 13mm socket wrench, remove 2 each bolts (G),
steel washers (F), and special washers (E) from the
stabilizer assembly (D).
3. Remove and discard old stabilizer.
4. Install new stabilizer in reverse order.
Bolt (A): 20-25 ft. lbs (27-34 Nm)
Bolt (G): 8 ft. lbs. (11 Nm)
A
G
B
A
B
C
D
E
F
11