Bin Control; Gearmotor - Cornelius Quantum 1000 Service Manual

Continuous Flow Icemaker Service Manual
B C
IN ONTROL
The type of bin control used on all WCC & WCF Models
is an electronic control. The control is supplied with
power to terminals X1 and X2. Terminals X3 and X4 are
a normally closed switch which open when the
thermostat sensor bulb senses ice.
The sensing element is located in a 5/16" stainless steel
tube which hangs from the dispense tray cover down
through the center of the drop tube.
To test switch, start the icemaker and block the outlet
tube. When the ice fills the drop tube about 1/2 full the
icemaker should shut off. When tube is cleared the ice
maker should restart within 5 min.
The Bin control is in electrical series with coil on antifreeze relay along with the low water safety. If unit is water
cooled, the condenser high pressure cut out is also in series.
The Control Switch is held in place inside electrical box by 2 screws. The Control bulb is in the drop tube. It can
be removed by pulling the cable located on the top of the dispense tray cover. When replacing the sensor make
sure the bulb is inserted to the bottom of the thermostat well.
G
EARMOTOR
The gearmotor is equipped with a start relay and a manual reset overload.
When current is applied, the relay energizes and completes the circuit to the start winding. The motor reaches a
predetermined speed and the relay drops out, disconnecting the start winding. The run winding remains in the
circuit as long as current is applied.
The purpose of the overload is to automatically shut off the motor in the event of a mechanical bind of the
transmission, an overload condition within the evaporator or an electrical malfunction. It does this by sensing
amperage draw. If the motor stalls the start relay would energize and stay energized. The amperage would surge 5
to 6 times greater than the normal draw. In this event the overload would shut off the transmission in 4 to 8
seconds.
If the motor is subjected to an abnormal load, but does not reach a stall condition, the overload will react, but over
a greater period of time. The reaction time depends upon the amperage to which it is subjected.
The overload, through the safety circuit, also shuts off the compressor.
Publication Number: 630460174SER

BIN CONTROL

SWITCH TERMINALS
Figure 4. Bin Control Switch
- 6 - © 2004-2011, IMI Cornelius Inc.