Cornelius 500 Series Installation Manual
Continuous flow icemaker
Hide thumbs
Also See for 500 Series:
- Installation and service manual (46 pages) ,
- Service manual (32 pages) ,
- Installation manual (28 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cornelius 500 Series
Summary of Contents for Cornelius 500 Series
- Page 1 CONTINUOUS FLOW ICE MAKER 500, 700, 1000, 2000 - Series Installation Manual Release Date: July 1, 2008 Publication Number: 630460174INS Revision Date: May 1, 2013 Revision: F Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.
-
Page 2: Contact Information
Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal... -
Page 3: Table Of Contents
TABLE OF CONTENTS Safety Instructions..............1 Read and Follow ALL Safety Instructions . -
Page 5: Safety Instructions
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE. © 2004-2013, IMI Cornelius Inc. - 1 - Publication Number: 630460174INS... -
Page 6: Safety Precautions
NOTE: If the appliance is to be limited to less than the above, this has to be clearly stated in the instructions. WARNING: Connect to potable water supply only. WARNING: To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. Publication Number: 630460174INS - 2 - © 2004-2013, IMI Cornelius Inc. -
Page 7: Installation Instructions
4. Filter/Conditioners are recommended on supply lines to icemakers. Never run the water supply to water cooled condenser through filter/conditioner, it uses up the cartridge unnecessarily and a saturated cartridge can starve the icemaker causing premature component damage. Separate water supplies are recommended. © 2004-2013, IMI Cornelius Inc. - 3 - Publication Number: 630460174INS... -
Page 8: Drain Connection
Install the extruder head on top of the evaporator, as shown in Figure 1. Auger/ Extruder Head Figure 1. 2. When the auger is lowered into the evaporator, rotate the auger to engage the motor drive shaft, see Figure 2. Publication Number: 630460174INS - 4 - © 2004-2013, IMI Cornelius Inc. - Page 9 This may cause excessive loads on the auger that can potentially result in excessive noise and tripping the drive motor overload. All tabs & slots engaged Figure 3. © 2004-2013, IMI Cornelius Inc. - 5 - Publication Number: 630460174INS...
-
Page 10: Initial Start Up, Checks And Adjustment Instructions
2. The WCC2001QT-R is equipped with an auger motor run delay. The auger motors will run after compressor shut down for approximately two minutes. This is to clear out the evaporators and is normal. Publication Number: 630460174INS - 6 - © 2004-2013, IMI Cornelius Inc. - Page 12 IMI Cornelius Inc. www.cornelius.com...
Need help?
Do you have a question about the 500 Series and is the answer not in the manual?
Questions and answers