Indicators; Input Status Indicators - Digital Projection LIGHTING 30-1080p User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
4. Controlling the projector

Indicators

Input status indicators

4. SDI
The indicator next to each input connector on the rear input panel will light as
follows:
off = input not selected
green = input selected, signal detected and in range
flashing green = input selected, but signal not detected or out of range
3D Sync IN
The indicator next to each input connector on the front input panel will light as
follows:
off = input not selected
flashing green = input selected
Page 4.8
All manuals and user guides at all-guides.com
Digital Projection
1. RGB1
7. Component 5. Composite Video
8. DVI:
MAIN
SUB
3D Sync OUT
LIGHTNING 1080p, 1080p 3D/UC
3. DVI
2. RGB2
6. S-Video
User Manual
Notes
There are more indicators on
the Control panel, and these are
described on the next page.
Input 8 and 3D may not be
present on some models
Rev B. January 2010