Mounting The Projector; Adjustment For Table Mounting; Adjusting The Rigging Frame; Coarse Frame Adjustment - Digital Projection LIGHTING 30-1080p User Manual

2. Installation

Mounting the projector

The projector is designed to be suspended from a lighting truss by its rigging
frame. However, the four adjustable feet under the chassis allow the projector to be
lowered onto a flat surface without any danger of hands being trapped between the
bottom frame and the surface.

Adjustment for table mounting

If the projector is to be operated from a flat surface such as a projector table, then
adjustment of projector level should be made by turning the four feet under the
chassis.

Adjusting the rigging frame

Before suspending the projector, make sure that the three frame adjusters and the
yaw adjustment are set roughly midway. Centering lines are scribed on the shafts to
show the centres of adjustment.

Coarse frame adjustment

Coarse adjustment of projector level should be made by adjusting the length of the
supporting wires or chains, or by adjusting the position of the truss.
Once the initial coarse frame adjustment has been made, fine adjustment should be
made using the three frame adjusters and the yaw handle (if fittled) on the rigging
frame.

Tilt and Roll adjustment

The frame adjusters can provide approximately ±10mm of vertical movement
relative to the rear right corner, giving approximately ±0.65° tilt and ±0.85° roll. It
is not possible, however, to achieve maximum adjustment in both tilt, roll and yaw
simultaneously.
Centering
line
Frame
adjuster
Page 2.16
All manuals and user guides at all-guides.com
Digital Projection
LIGHTNING 1080p, 1080p 3D/UC
User Manual
Notes
BEFORE INSTALLING THE
PROjECTOR, READ ALL THE
WARNINGS BELOW AND
ALL THOSE IN IMPORTANT
INFORMATION AT THE
FRONT OF THIS MANUAL.
The projector weighs over
100kg (200lbs). Use safe
handling techniques when
lifting the projector.
Make sure that the surface,
ceiling or rigging that is
to support the projector
is capable of supporting
the combined weight of
the projector and lens (see
specification for weights).
Backup safety chains or
wires should always be used.
Do not tilt the projector more
than ±12° from side to side
when in use, as this may
cause serious lamp failure,
damage the lamp module
and cause extra cost on
replacement. The projector
my be tilted forwards and
backwards as necessary.
±12°
360°
Rev B. January 2010