Using The Menus; Navigating Menus And Submenus - Digital Projection LIGHTING 30-1080p User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
4. Controlling the projector

Using the menus

Navigating menus and submenus

When the menus are in use and the OSD is ON, the top level menu headings are
always visible to the left of the screen.
Each menu item can lead to a number of submenus, which are displayed in the
column to the right . The
Each submenu can lead to further submenus, up to a maximum of three levels.
• To display the menus, press
• The menus will always open at the same point they were last viewed. The
example below shows the first menu display following power on – the item that is
currently selected (the Input menu) is highlighted in blue.
• To select a menu, press
Page 4.16
All manuals and user guides at all-guides.com
Digital Projection
symbol indicates that a submenu is available.
on the remote control or the keypad.
and , for example the Setup menu:
LIGHTNING 1080p, 1080p 3D/UC
Main menu: Input
Main menu: Setup
User Manual
Notes
Some menu controls can be
accessed directly using the
control keys (see earlier in this
section).
When the OSD is OFF, all menu
navigation keys will be disabled.
When the OSD is switched back
ON, the menus will remain OFF
until the key is pressed
again. The menus will then
reopen at the same point they
were last viewed.
If a menu is opened, and no
other key is pressed within the
period set in the OSD Timeout
menu, then the menus will
disappear. When the
is pressed again, the menus will
reopen at the same point they
were last viewed.
(see On Screen Display,
in Setup Menu, later in this
section).)
Rev B. January 2010
key