Error Messages - Endress+Hauser Liquicap M FMI51 Operating Instructions Manual

Liquicap M FMI51, FMI52
3) See Section 9.2, "System error messages" for information on the difference between a "Warning" and an "Alarm".
Endress+Hauser
empty calibr.
value empty
value empty : 0.000
5.500
measure capacity : 1.79
confirm cal. : yes
–
Delete: The current position and all positions to the right of this position are deleted.
Return to the measured value display
CLX01
medium property
no build up
build up
↑
Â
↑
Pressing the left and center key simultaneously has the following effect:
• Takes you from the editing mode to the display mode of the functions
• Takes you from the display mode of the functions to the submenu
• Takes you from the submenu to the main menu
• Takes you from the main menu to the measured value display.
5.2

Error messages

If the automatic monitoring function of Liquicap M detects an error, the related softkey symbol
appears over the center key.
If the softkey symbol is flashing, only "Warning"-type errors are present
If the symbol is displayed continuously, at least one "Alarm"-type error is present
Once you press the key, a list appears with all the errors currently pending.
CLX04
empty calibr.
% value empty : 0.000
%
pF measure capacity : 1.79
confirm cal. : yes
↵
+
CLX00
basic setup
medium : no build up
unit level : %
cal. type : wet
↵
↑
↑
Operation
CLX04
value empty
%
5.5 %
pF
↵
– +
L00-FMI5xxxx-19-05-xx-en-009
CLX00
basic setup
medium : no build up
unit level : %
cal. type : wet
↵
L00-FMI5xxxx-19-05-xx-en-010
3)
3
vor.
. . .
51