Manufacturer's Information; Delivery; Packaging; Transport - GEM Q40 Operating Instructions Manual

7 Manufacturer's information

7.1 Delivery

● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.

7.2 Packaging

The product is packaged in a cardboard box which can be re-
cycled as paper.

7.3 Transport

1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.

7.4 Storage

1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.

8 Installation

8.1 Preparing for installation

The equipment is subject to pressure!
▶ Risk of severe injury or death
Depressurize the plant.
●
Completely drain the plant.
●
Corrosive chemicals!
▶ Risk of caustic burns
Wear appropriate protective gear.
●
Completely drain the plant.
●
Hot plant components!
▶ Risk of burns
Only work on plant that has cooled
●
down.
www.gemu-group.com
WARNING
WARNING
CAUTION
Use as step.
▶ Damage to the product
▶ Risk of slipping-off
Choose the installation location so that the product can-
●
not be used as a foothold.
Do not use the product as a step or a foothold.
●
Suitability of the product.
▶ The product must be appropriate for the tube's operating
conditions (medium, medium concentration, temperature
and pressure) and the respective ambient conditions.
Requirements for tube lines used!
▶ Use tube lines suitable for the application, see manufac-
turer's information.
Only use undamaged tube lines.
●
Lay tube lines professionally!
▶ Lay tube lines professionally and do not bend them below
the minimum bending radius, see manufacturer's inform-
ation.
Do not kink or twist the tube lines.
●
Tools
▶ The tools required for installation and assembly are not
included in the scope of delivery.
Use appropriate, functional and safe tools.
●
1. Ensure the product is suitable for the relevant application.
2. Check the technical data of the product and the materials.
3. Keep appropriate tools ready.
4. Use appropriate protective gear as specified in plant oper-
ator's guidelines.
5. Observe appropriate regulations for connections.
6. Installation work must be performed by trained personnel.
7. Shut off plant or plant component.
8. Secure the plant or plant component against recommis-
sioning.
9. Depressurize the plant or plant component.
10. Completely drain the plant or plant component and allow it
to cool down until the temperature is below the media va-
porization temperature and cannot cause scalding.
11. Pay attention to the installation position (see chapter "In-
stallation position").

8.2 Installation position

The installation position of the product is optional.
27 / 36
8 Installation
CAUTION
NOTICE
NOTICE
NOTICE
NOTICE
GEMÜ Q40