Table of Contents
Advertisement
Part Names and Functions
Top Control
q ALARM indicator
Blinks red when informing the setting or battery
status (pp.58–59).
w LAMP REPLACE indicator
Lights yellow when the projection lamp reaches its
end of life (pp.65, 71).
e ON/STAND–By button
Turn the projector on or off (pp.22–23).
r INPUT button
Select an input source (pp.30–31, 40–41).
t KEySTONE button
Correct keystone distortion (pp.26, 48).
(VOLUME +/–) buttons
ed7 8
y POINT
– Select an item or adjust the value in the
On-Screen Menu (p.24).
– Pan the image in the Digital zoom + mode (p.39).
– Adjust the volume level (Point
u SELECT button
– Execute the selected item (p.24).
– Expand or compress the image in the Digital zoom
mode (p.39).
1
q
w
e
r
t
y
u
i WARNING indicator
o POWER indicator
!0 AUTO SETUP/CANCEL button
buttons) (p.27).
7 8
!1 MENU button
i
o
!0
!1
– Lights red when the projector detects an abnormal
condition.
– Blinks red when the internal temperature of the
projector exceeds the operating range (pp.62, 71).
– Lights red when the projector is in stand-by mode.
– Lights green during operations.
– Blinks green in the Power management mode
(p.52).
–Correct vertical keystone distortion and adjust
computer display parameters such as Fine sync.,
Total dots, and Picture position (pp.26, 47).
–Display the image in SD card or return to the
menu bar in Memory Viewer menu.
Refer to the owner's manual of "Network Set-up
and Operation" and owner's manual of Memory
viewer.
Open or close the On-Screen Menu (p.24).
Advertisement
Table of Contents
