Table of Contents
Advertisement
Part Names and Functions
Top Control
① SELECT button
– Execute the selected item (p.23).
– Expand or compress the image in the Digital zoom
mode (p.38).
② POINT
(VOLUME +/–) buttons
▲▼◄►
– Select an item or adjust the value in the On-Screen
Menu (p.23).
– Pan the image in the Digital zoom + mode (p.38).
– Adjust the volume level (Point
③ AUTO SETUP/CANCEL button
–Correct vertical keystone distortion and adjust
computer display parameters such as Fine sync.,
Total dots, and Picture position (pp.25, 46).
–Display the image in SD card or return to the
menu bar in Memory Viewer menu.
Refer to the owner's manual of "Network Set-up
and Operation" and owner's manual of Memory
viewer.
④ POwER indicator
– Lights red when the projector is in stand-by mode.
– Lights green during operations.
– Blinks green in the Power management mode
(p.51).
⑩
⑨
⑧
⑦
⑤ LAMP REPLACE indicator
Lights yellow when the projection lamp reaches its
end of life (pp.60, 68).
⑥ wIRELESS indicator
Turn green when the projector is in the network
mode.
⑦ MENU button
Open or close the On-Screen Menu (p.23).
buttons) (p.26).
◄►
⑧ INPUT button
Select an input source (pp.29–30, 39–40).
⑨ ON/STAND–By button
Turn the projector on or off (pp.21–22).
⑩ wARNING TEMP . indicator
– Lights red when the projector detects an abnormal
– Blinks red when the internal temperature of the
⑥
⑤
④
③
②
①
condition.
projector exceeds the operating range (pp.57, 68).
11
Advertisement
Table of Contents
