Operation - Kärcher K 3.20 M Manual

Operation

Scope of delivery
The scope of delivery of your appliance is illus-
trated on the packaging. Check the contents of
the appliance for completeness when unpack-
ing.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
Description of the Appliance
These operating instructions describe the maxi-
mum equipment. Depending on the model, there
are differences in the scopes of delivery (see
packaging).
Illustrations on Page 2
1 Coupling element for water connection
2 High pressure connection
3 Appliance switch "0/OFF"/ „I/ON"
4 Storage for trigger gun
5 Transport handle
6 Storage for accessories
7 Mains cable with mains plug
8 Suction hose for detergent
9 Connection for water supply with filter
10 Trigger gun
11 Lock trigger gun
12 High pressure hose
13 Spray lance with Dirtblaster
14 Spray lance with pressure regulation (Vario
Power)
Special accessories
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Before Startup
Illustration
Mount loose parts delivered with appliance prior
to start-up.
Illustration
Push the high pressure hose into the trigger
gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling on
the high-pressure hose.
Water supply
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work with
the KÄRCHER suction hose with backflow valve
(Optional accessory, order no. 4.440-238) to
draw in surface water, e.g. from water butts or
ponds (see specifications for max. suction
height).
Fill the KÄRCHER suction hose with back-
flow valve with water, screw to water supply
and hang into he water butt.
Separate the high pressure hose from the
high pressure connection of the appliance.
Switch the appliance on "I/ON" and operate
until the water exits the high-pressure con-
nection without bubbles.
Turn off the appliance "0/OFF".
English 11
5
Deutsch