Table of Contents
Advertisement
Removing an interface module
CAUTION:
If you are not to install a new interface module after removing the original one, install a filler panel in
the slot to prevent dust and ensure good ventilation.
To remove an interface module:
1.
Prepare an anti-static bag.
2.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
grounded.
3.
To avoid cable damage, remove cables from the interface module before removing the module.
4.
Press down and hold the latch of the ejector lever to pull the ejector lever out.
5.
Open the ejector lever to disengage the interface module from the device connector.
6.
Use both hands to slowly take the module out.
7.
Place the removed interface module on an anti-static mat or in an anti-static bag.
Figure2-28 Removing an LSWM116H interface module
1
Verifying the installation
After you complete the installation, verify the following items:
•
There is enough space around the switch for heat dissipation.
•
The rack is sturdy and stable.
•
The grounding cable is securely connected.
•
The power supplies are as required by the switch.
•
The power cords are correctly connected.
•
The network cable is routed indoors. The switch does not support outdoor cable routing.
2
2-24
Advertisement
Table of Contents
