802.3X Function Setting Jp2; Fx Duplex Setting Jp3; Jp1-Jp3 Factory Default Settings - KTI Networks NC-300D Series Installation Manual

3.1.2 802.3x Function Setting JP2

IEEE 802.3x function is the flow control method used for full duplex op-
eration on TP port and FX port under store and forward mode. This
method uses pause frames for one port to stop further transmission from
its link partner.

3.1.3 FX Duplex Setting JP3

This setting is used to set the duplex mode of the FX port.

3.2 JP1-JP3 Factory Default Settings

The factory default settings for JP1, JP2, and JP3 are as follows:
JP1 Open Store-and-forward mode
JP2 Open 802.3x function is enabled
JP3 Open FX port full duplex
-19-