ABB Relion 670 Series Commissioning Manual page 107

1MRK 505 372-UUS Rev. K
10.5.2 Two step overvoltage protection OV2PTOV (59)
Prepare the IED for verification of settings as outlined in section
for test" in this chapter.
10.5.2.1 Verifying the settings
Verification of single-phase voltage and time delay to trip for Step 1
1. Apply single-phase voltage below the set value Pickup1.
2. Slowly increase the voltage until the PU_ST1 signal appears.
3. Note the trip value and compare it with the set value Pickup1.
For phase-to-ground measurement:
Vpickup
ANSIEQUATION2426 V1 EN-US
For phase-to-phase measurement:
Vpickup
ANSIEQUATION2427 V1 EN-US
4. Decrease the voltage slowly and note the reset value.
5. Set and apply about 20% higher voltage than the measured trip value for one phase.
6. Measure the time delay for the TRST1 signal and compare it with the set value.
7. Check the inverse time delay by injecting a voltage corresponding to 1.2 × Vpickup>.
8. Repeat the test to check the inverse time characteristic at different over-voltage levels.
9. Repeat the above described steps for Step 2 of the function.
10.5.2.2 Extended testing
1. The tests above can be repeated for 2 out of 3 and for 3 out of 3 operation mode.
10.5.2.3 Completing the test
Continue to test another function or end the test by changing the TESTMODE setting to Disabled.
Restore connections and settings to the original values, if changed for testing purposes.
10.5.3 Two step residual overvoltage protection ROV2PTOV (59N)
Prepare the IED for verification of settings outlined in Section
Busbar protection REB670
Commissioning manual
The trip value in secondary volts is calculated according to the following equations:
>
VBase VT sec
´ ´
100 VTprim
3
>
VT sec
´ ´
VBase
100 VTprim
© 2017 - 2022 Hitachi Energy. All rights reserved
Testing functionality by secondary injection
"Requirements" and section
GUID-BE4B4A36-CCEE-4020-B7DC-6A83A43D11F5 v2
"Preparing the IED to verify
Section 10
M13806-2 v6
"Preparing
M13806-9 v2
M13806-50 v10
(Equation 18)
(Equation 19)
M13806-43 v6
SEMOD54358-3 v7
settings".
101