Aqualisa UNITY Q UTQ.A2.BV.DVFC.20 User Manual page 7

Set up Shower - Controller
Wifi setup can only be activated
via the main controller and not
via a remote (where installed).
For shower controllers
(2 buttons): Press and hold the
Top button for 6-8 seconds.
For bath controllers
(1 large button):
Press and hold the button
for 6-8 seconds.
The LEDs on the controller will flash rapidly to indicate
that the Aqualisa SmartValve™ is searching for an
available Wifi network. N.B. There is a 2-minute time out
if unable to connect.
Set up Shower - Wifi
The Aqualisa app will direct you to the Wifi settings
menu on your mobile device.
From the list of available Networks select: QSVC XXXX
The password is: SmartShower (case sensitive)
N.B. Depending on signal strength, the connection
may take a few minutes. You do not need to wait for
connection confirmation. Go back to the Aqualisa app
and follow the steps, for these stages you will need your
SSID code and password.
12
The LEDs will flash slowly to indicate the Aqualisa
SmartValve™ is connected to the Aqualisa app and will
switch to being solid to indicate a successful connection
to your selected Home Wifi.
A successful connection message will provide confirmation
in the Aqualisa app journey and the LEDs on the controller
will turn off to indicate that the shower is ready for use.
If connection is unsuccessful a message will appear in your
Aqualisa app. Redo the steps above or refer to Aqualisa
app troubleshooting on page 19 or at
www.aqualisa.co.uk/smartapp.
Smart Speaker Set up
Once the Aqualisa app is set up and the shower connected, go to the app for your
smart speaker and follow their instructions to add the Aqualisa home to your devices.
The Aqualisa app gives you the capability to operate your product
remotely using your mobile device. It is the responsibility of the user
to ensure that it is safe to remotely activate the water flow. Aqualisa
recommend that baths and showers in operation are not left unattended.
If the timer setting is adjusted within the Aqualisa app, then the shower will
run for the newly set duration, overriding the default maximum run time.
N.B. The water flow will stop at the end of the timer.
IMPORTANT: see page 6 " " for special notes regarding Unity Q™ bathfill.
13