Graco 256282 Instructions Manual page 6

Registering the Meter
REGISTER Screen
REGISTER
NETWORK ID 8 TRANS ID
A
REGISTER REGISTER C
F . 5
IG
A. NETWORK ID: The unique Radio Frequency (RF)
assigned to components of the same operating system
in a specific facility. The unique NETWORK ID assigned
to the facility, prevents RF interference from other Matrix
Systems operating in the vicinity, at other locations.
There are 8 NETWORK ID's available.
To setup a meter to receive the correct NETWORK ID
RF signal, use the UP or DOWN ARROWS to scroll, one
number at a time, through the NETWORK ID numbers
(1-8). When the correct NETWORK ID number assigned
to your facility is displayed in the field/box, press center
ENTER button on meter's keypad to lock in the choice.
B. TRANS ID: The unique RF frequency assigned to a
specific transceiver in the operating system. Each
transceiver in the system has its own TRANS(ciever) ID
number assigned to it. An operating system can have
more than one transceiver. There are 8 TRANS ID's
available.
To set up a meter to receive the correct TRANS ID RF
Signal, use the UP or DOWN ARROWS to scroll, one
number at a time, through the TRANS ID numbers (1-8).
When the number assigned to the transceiver you are
using displays in the field/box, press center ENTER
button on meter's keypad to lock in the choice.
C. REGISTER /field: Sends message to Matrix PC
Software to register the meter with the operating
system.
Use the LEFT or RIGHT ARROWS to move the cursor
over the REGISTER field/box on the display. Then press
center, ENTER button on meter's keypad, to confirm the
selection.
6
D. WRENCH Icon: Returns user to Main Utility Screen.
Use the LEFT or RIGHT ARROWS to move the cursor
over the WRENCH Icon on the display. Then press
center, ENTER button on meter's keypad, to confirm the
selection.
6
E. SERIAL Number: Unique meter ID.
B
Registering Meter with Matrix PC Software
E 1. The screen displays the NETWORK ID (A) and
123F456A
D
ti12260a
2. If the ID's in both fields are correct and you do not
TRANS(ceiver) ID (B) (F
the meter.
need to make any changes, use LEFT or RIGHT
ARROWS to move cursor over REGISTER (C).
Press center ENTER button on meter's keypad. The
meter resets to it's initial screen.
OR . . .
If the NETWORK ID or TRANS ID information
shown on the display is NOT correct:
a. Use LEFT or RIGHT ARROWS to move cursor
to NETWORK ID field and/or TRANS ID field.
b. When field you want to modify is selected, use
UP or DOWN ARROWS to scroll forward or
backward through the available NETWORK ID
or TRANS ID numbers.
c. When correct ID number displays, press center
ENTER button on meter's keypad to confirm
your choice. If necessary, use LEFT or RIGHT
ARROWS to move cursor to the next field and
repeat this procedure.
d. When both the NETWORK ID and TRANS ID
fields display the correct information, use LEFT
or RIGHT ARROWS to move cursor over REG-
ISTER. Press center ENTER button on the
meter's keypad to complete meter registration.
. 5) currently assigned to
IG
313046A