Graco 256282 Instructions Manual page 15

Setup
Battery Indicator
A battery icon appears on the upper right corner of most
Setup and Dispense screens. When the batteries are
fully charged, the battery will be completely filled in. As
the battery discharges, the amount of battery that is
filled in will decline. For example, the battery in F
at about 50%.
NOTE: The meter's operating parameters are controlled
by the Matrix PC Software and setup by the System
Administrator. See the Matrix 3 Software instruction
manual for these instructions.
Meter Calibration
Meter calibration is performed using the Matrix PC
software. Refer to the Matrix 3 Software instruction
manual for this procedure.
Security Modes
When the meter was originally programmed by the
system administrator, one of the following security
choices was entered:
• PIN Code
• Parts Room Authorization
• System Monitoring
Prior to dispensing, it may be necessary to complete
one of the following security procedures, depending on
the security mode set by the system administrator.
313046A
. 20 is
IG
ENTER
F . 20
IG
PIN Code (F
ENTER
F . 21
IG
PIN Code (Personal Identification Number) means that
a four digit number must be entered at the meter before
every new dispense to obtain dispense authorization.
To use a meter with PIN Code security:
1. Use the UP or DOWN ARROWS to select the first
PIN Code number field.
MOBIL 1 5W-20
PIN CODE
2 1 2 2
. 21)
IG
MOBIL 1 5W-20
PIN CODE
2 1 2 2
Setup
ti12255a
15